Siemens SIMATIC NET SCALANCE W780 Series User Manual

Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
393
●
Add
To permanently assign the ACL rule to the interface, click the "Add" button. The
configuration is shown in the table.
●
Remove Rule
From the "Remove rule" drop-down list, select the ACL rule to be deleted.
●
Remove
To remove the ACL rule from the interface, click the "Remove" button.
The table has the following columns:
●
Rule Order
Shows the order of the ACL rules.
●
Rule Number
Shows the number of the ACL rule.
●
Protocol
Shows the protocol for which this rule is valid.
●
Protocol Number
Shows the protocol number.
●
Source IP
Shows the IPv4 address of the source.
●
Source Subnet Mask
Shows the subnet mask of the source.
●
Dest IP
Shows the IP address of the destination.
●
Dest. Subnet Mask
Shows the subnet mask of the destination.
●
Action
Select whether the frame is forwarded or rejected when it corresponds to the ACL rule.
– Forward
If the frame complies with the ACL rule, the frame is forwarded.
– Discard
If the frame complies with the ACL rule, the frame is not forwarded.
●
Source Port Min.
Shows the lowest possible port number of the source port.
●
Source Port Max.
Shows the highest possible port number of the source port.
●
Dest. Port Min.
Shows the lowest possible port number of the destination port.
●
Dest. Port Max.
Shows the highest possible port number of the destination port.

Siemens SIMATIC NET SCALANCE W780 Series Specifications

General

Brand	Siemens
Model	SIMATIC NET SCALANCE W780 Series
Category	Wireless Access Point
Language	English