Siemens SIMATIC RF650R

Programming via SIMATIC controller
8.6 Programming the Ident profile
SIMATIC RF650R/RF680R/RF685R
146 Configuration Manual, 03/2018, C79000-G8976-C386-06
Overview of the commands
Table 8- 34 Overview of the commands with which chaining is possible
Command
Command code
Description
HEX
ASCII
PHYSICAL-READ 70 'p' Reads data from a transponder by specifying the
physical start address of the memory bank (UHF), the
length and the password.
PHYSICAL-WRITE 71 'q' Writes data to a transponder by specifying the physi-
cal start address of the memory bank (UHF), the
length and the password.
INVENTORY
1)
69 'i' Requests a list of all currently accessible transpond-
ers within the antenna range.
DEV-STATUS 74 't' Reads out the status of a communications module.
This command must not be the last command within
the chain.
WRITE-ID 67 ‘g‘ RF680R/RF685R:
Writes a new EPC-ID to the transponder.
KILL-TAG 6A ‘j‘ RF680R/RF685R:
The transponder is permanently deactivated.
LOCK-TAG-BANK 79 ‘y‘ RF680R/RF685R:
Defines a password for transponder access.
1)
Note that chaining of commands must not start with the "INVENTORY" command, because the
"INVENTORY" command is executed directly.