Siemens SIMATIC RF650R

Programming via XML interface
10.3 XML commands
SIMATIC RF650R/RF680R/RF685R
214 Configuration Manual, 03/2018, C79000-G8976-C386-06
10.3.2.12
getIO
This command requests the current status of all inputs and outputs of the reader.
Command
<frame>
<cmd>
<id> value_id </id>
<getIO/>
</cmd>
</frame>
Reply
<frame>
<reply>
<id> value_id </id>
<resultCode> 0 </resultCode>
<getIO>
<returnValue>
<inValue> value_inValue </inValue>
<outValue> value_outValue </outValue>
</returnValue>
</getIO>
</reply>
</frame>
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 263)".