Siemens SIMATIC RF650R

To Next Page

To Previous Page

Programming via XML interface

10.3 XML commands

SIMATIC RF650R/RF680R/RF685R

246 Configuration Manual, 03/2018, C79000-G8976-C386-06

10.3.3.9

readTagField

This command reads data from the selected transponder. The address of the data area is

specified by the name of a tag field. The tag field and the name of the field are specified

using the WBM. If no EPC-ID is made available or detected, the command is executed with

all the transponders recognized from the read point.

Note

If no EPC

-ID is specified, the results are influenced by all the set filter mechanisms (refer to

the section "

The "Settings - Filters" menu item (Page 68)"). Then in the reply frame, only the

tags that were not filtered out appear. If an EPC

-ID is specified, the data filter has no effect.

The reply frame contains the IDs of all identified transponders. A flag for each transponder

indicates whether or not the command was successful for this transponder.

If no transponder was identified, a negative reply is returned.

Command

<frame>

<cmd>

<id> value_id </id>

<sourceName> value_sourceName </sourceName>

<tagID> value_tagID </tagID> // opt

<password> value_password </password> // opt

<fieldName> value_fieldName </fieldName>

</tagField>

…

<tagField> // opt

…

</tagField> // opt

</readTagField>

</cmd>

</frame>

// opt → Optional: Line can be omitted.

Other manuals for Siemens SIMATIC RF650R