Siemens SIMATIC RF650R

Programming via XML interface
10.3 XML commands
SIMATIC RF650R/RF680R/RF685R
220 Configuration Manual, 03/2018, C79000-G8976-C386-06
10.3.2.16
getAntennas
The command returns all antennas that are configured at the specified read point.
This command is supported as of API protocol version V2.1.
Command
<frame>
<cmd>
<id> value_id </id>
<getAllAntennas>
<sourceName> value_ sourceName <sourceName>
</getAllAntennas>
</cmd>
</frame>
Reply
<frame>
<reply>
<id> value_id </id>
<resultCode> 0 </resultCode>
<getAllAntennas>
<returnValue>
<antennaName> value_antennaName </antennaName>
…
<antennaName> value_antennaName </antennaName> // opt
</returnValue>
</getReaderStatus>
</reply>
</frame>
// opt → Optional: Line can be omitted.
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 263)".