Description
3.2 User-specific procedures
SIMATIC RF650R/RF680R/RF685R
20 Configuration Manual, 03/2018, C79000-G8976-C386-06
Procedure as Rockwell user
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 25)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 29)" or "Assigning an IP address via DHCP (Page 33)".
3. Configure the reader
You will find information on this in the sections "Configuring with Studio 5000 Logix
Designer (Page 39)" and "Configuring with the WBM (Page 41)".
4. Configure / program reader commands
You will find information on this in the section "Programming via Rockwell controller
(Page 155)".
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 25)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 29)".
3. Configure the reader
You will find information on this in the section "Configuring with the WBM (Page 41)".
4. Program reader commands
You will find information on this in the section "Programming via XML interface
(Page 185)".
Procedure as an OPC UA user
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 25)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 29)".
3. Configure the reader
You will find information on this in the section "Configuring with the WBM (Page 41)".
4. Program reader commands
You will find information on this in the section "Programming via the OPC UA interface
(Page 277)".
To Next Page
Loading...
Need help?
General