Siemens SIMOTICS S-1FL6

Getting Started
A5E37208904-003, 04/2017
57
5.1
Introduction to the BOP
Overview
The SINAMICS V90 PN servo drive is designed with a Basic Operator Panel (BOP) on the front panel of the servo drive:
You can use the BOP for the following operations:
● Standalone commissioning
● Diagnosis
● Parameter access
● Parameter settings
● Micro SD card/SD card operations
● Drive restart
LED status indicators
Two LED status indicators (RDY and COM) are available to indicate drive status. Both LEDs are tricolor (green/red/yellow).