Getting Started
58 A5E37208904-003, 04/2017
You can find detailed information about the status indications in the table below:
24 V control board power supply is missing
The drive is in "servo on" state
The drive is in "servo off" state or in the startup state
Flash alternatively at
2 Hz
PROFINET communication is working with IRT
PROFINET communication is working with RT
Micro SD card/SD card operating (read or write)
Red Continuously lit Communication error (always put the PROFINET communica-
tion error as the first consideration)
• Exits from the current menu
• Switches between operating modes in the top level
menu
• Confirms selection or input
• Enters sub menu
• Acknowledges faults
Long-pressing:
Activates auxiliary functions
• JOG
• Saves parameter set in drive (RAM to ROM)
• Sets parameter set to default
• Transfers data (drive to micro SD card/SD card)
• Transfers data (micro SD card/SD card to drive)
•
UP button
• Navigates to the next item
• Increases a value
• JOG in CW (clockwise)
DOWN button
• Navigates to the previous item
• Decreases a value
• JOG in CCW (counter-clockwise)
SHIFT button Moves the cursor from digit to digit for single digit editing,
including the digit of positive/negative sign
When the sign is edited, "_" indicates positive and "-" indi-
Press the key combination for four seconds to restart the drive
Moves current display to the left page when
is displayed at the upper right corner, for
example .
Moves current display to the right page when
is displayed at the lower right corner, for
example .