Siemens SIMOTICS S-1FL6 User Manual

Connecting
4.3 Control/status interface - X8
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
147
1)
When connect to axis 1, the outputs are DO a.1 and DO a.7;
When connect to ax
is 2, the outputs are DO a.3 and DO b.0.
*
The resistor R3 (200 Ohm to 500 Ohm) is required only if the speed for searching the
zero position exceeds 300 rpm.
**
The resistor R (200 Ohm to 500 Ohm, recommended power ≥ 5 W ) is required only if
the PTI input frequency exceeds 100 KHz.

Siemens SIMOTICS S-1FL6 Specifications

General

Brand	Siemens
Model	SIMOTICS S-1FL6
Category	Servo Drives
Language	English