Basic operator panel (BOP)
6.5 Auxiliary functions
SINAMICS V90, SIMOTICS S-1FL6
Operating Instructions, 04/2019, A5E36037884-007
201
Saving parameters (RAM to ROM)
This function is used for saving a parameter set from the drive RAM to drive ROM. To use
this function, proceed as follows.
Note
Plugging or unplugging the micro SD card/SD card will cause saving failure.
Do not plug or unplug the micro SD card/SD card during saving; otherwise, the saving
operation will fail.
If a micro SD card/SD card has been inserted, the parameter set will be saved onto the
micro SD card/SD card simultaneously.
All signal functions become inactive during the saving process. Use the signal functions
afterwards.
Editing parameters (Page 196)
To Next Page
Loading...
