Siemens SIMOTICS S-1FL6

Basic operator panel (BOP)
6.5 Auxiliary functions
SINAMICS V90, SIMOTICS S-1FL6
202 Operating Instructions, 04/2019, A5E36037884-007
6.5.3
Setting parameters to default
This function is used to reset all parameters to their default values. To use this function,
proceed as follows.
Note
You must
save the parameter set after setting the parameter set to the default values;
otherwise, the default values will not be saved to
drive ROM.
Reference
Saving parameters (RAM to ROM) (Page 201)