Siemens SINUMERIK 810D User Manual

5
03.04 "Parameters" Operating Area
5.1 Tool data
5
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 5-181
Technology
$TC_DP24 Reserved Reserved Reserved Reserved
$TC_DP25 Reserved Reserved Reserved Reserved
Additional parameters
$TC_DPC1
up to
$TC_DPC10
* Value of the chaining parameter if the compensation parameters is to be chained.
Parameter no. for radius
calculation
$TC_TPG9
With this parameter it is possible to define which offset value is used
for grinding wheel surface speed, tool monitoring and centerless
grinding. The value always refers to cutting edge D1.
$TC_TPG9 = 3 Length 1 (geometry + wear + base, depending on tool type)
$TC_TPG9 = 4 Length 2 (geometry + wear + base, depending on tool type)
$TC_TPG9 = 5 Length 3 (geometry + wear + base, depending on tool type)
$TC_TPG9 = 6 Radius
*: The tool parameter of cutting edge 2 is chained to the parameter of
cutting edge 1 (see tool-specific grinding data $TC_TPG2, chain rule).
Here, typical chains are shown and the associated place value is
specified in brackets.
Spindle number
$TC_TPG1 $TC_TPG1
This parameter contains the number of the spindle to which the
monitoring data and GWPS refer.
Chain rule
$TC_TPG2 $TC_TPG2
This parameter defines which tool parameters of the right wheel edge
(D2) and left wheel edge (D1) must be chained (see TOA data). If the
value of one of the chained parameters is changed, it is then
automatically included in the chained parameter.
It must be noted that the minimum grinding wheel radius must be
specified in the cartesian coordinate system for an inclined grinding
wheel. The length compensations always specify the distances
between the tool holder reference point and the tool tip in Cartesian
coordinates.
The monitoring data apply to both the left-hand and the right-hand
cutting edge of the grinding wheel.
The tool lengths are not automatically compensated when the angle is
altered.
With inclined axis machines, the same angle must be used for the
inclined axis and the inclined grinding wheel.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English