Siemens SINUMERIK 810D User Manual

6
"Program" Operating Area 03.04
6.8 Multi-channel ste
p
dis
p
la
y
(
o
p
tion from SW 6.4
)
6
Ó Siemens AG, 2004. All rights reserved
6-306 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Standardized view
Features Each step is displayed with the same length, regarded of its contents.
Step identifiers are displayed for the program which currently has the
focus. Status: "Program data was modified" is not displayed in the
Program screen of channel 1.
Time proportional view
Features Steps are displayed in proportion to the duration of their execution
time. With wait markers, the step length is displayed proportional to
the wait time.
Precondition Time computation must have been performed by execution of the
workpiece program. If the time computation was not performed,
standardized view is displayed. Programs which were modified after
the time computation are marked with "Data modified". Computing the
time again sets all programs to "Data updated". See below.
Time computation Preparatory phase: Message: Time computation is initialized. Please
wait....
Initiation of execution: Message: Time computation is active.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English