6
03.04 "Program" Operating Area
6.9 Pro
ram simulation
6
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 6-321
Turning
Machine arrangement in front or behind turning center.
Spindle
settings
Milling
Turning
Leads to the manufacturer-specific spindle settings (subject to correct
password).
currently unused
Defines longitudinal offset for main spindle and counterspindle,
longitudinal mirroring on/off, NC keyword definitions for spindle
switchover.
Copy
Copy selected line of machining list to clipboard.
Paste
Insert the machining list line that was copied/deleted from the
clipboard at the position of the selected line (the selected line is
moved down one row).
Delete
Delete the selected line from the machining list
Abort
OK
Return to main simulation menu: Modifications to the current
machining list are not saved
Return to main simulation menu: Modifications to the current
machining list are saved and activated with the information displayed
Channel/
spindle
Additional note
1. To activate the machining list after a workpiece selection, it
must be selected explicitly at least once with the softkey
"Channel/spindle". The list is displayed implicitly every time a
program is subsequently selected from the same workpiece
directory so that it can be added to as required. It only makes
sense to define a simulation sequence using the machining list
"Channel/spindle" provided if the overlay principle for part
machining is used (..i.e. when the simulation result of several part
programs in succession is to be viewed at a single blank). In these
cases please pay particular attention to the notes in the lower edge
of the screen. They contain e.g. lines for which an intermediate
model was already created, special status display, etc. By
selecting such a line in the machining list you can place the
simulation directly on the associated intermediate model again.
To Next Page
Loading...
Need help?
General
