Siemens SINUMERIK 810D User Manual

2
Operator Components/Sequence of Operations 03.04
2.2 O
p
erator
p
anel ke
y
s
2
Ó Siemens AG, 2004. All rights reserved
2-38 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Note
The keys marked with an * also have a function in conjunction with
ShopMill/ShopTurn.
SW 6.3 and higher PROGRAM hardkey
Press this hardkey in any operating area to open and display the part
program or file last edited in the Program operating area:
· If you are already in the Program operating area and the editor is
open, the program you last edited is displayed.
· If you are in any other operating area, and the editor is open, you
jump back to the editor in the Program operating area and the
most recent editor status is displayed.
If the editor is not open:
· If you are in another user application, you jump back to the
Program operating area and the editor is opened with the program
you last edited.
For this function to work, at least one recently edited program must be
found with sufficient read rights. The program must not be already
open in either a simulation or any other application. Actions such as
load, copy, select, etc. must not be in progress and the part program
must not be running on the NC.
In the above cases, the operation is denied with alarms 1203xx.

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English