4
03.04 Machine Operating Area
4.4 JOG mode
4
Ó Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition 4-121
Spindle
Spindle screen (if spindle is available)
The window contains the spindle setpoint and actual value, position,
setting of spindle override switch
and spindle output.
Nibbling
The spindle window is replaced by a nibble window if the "Nibbling"
technology option is set.
The active function, if any, appears at the top left in the window
header:
· PON Punching ON
· SON Nibbling ON
· SPOF Punching/nibbling OFF
Feed
Feed window
Display of the setpoint and actual value of the feedrate as well as the
position of the feedrate override switch
(in %). The actual
setpoint to be traversed is dependent on the override switch.
When G00 (rapid traverse movement) is programmed, the rapid
override value is displayed.
As of SW 6.2:
If the feedrate is not enabled, the symbol "Feedrate not enabled"
is output in the feedrate window. (FST is not indicated in the "program
control display" field).
Tool
Tool window
Display of active tool offset (e.g. D1), tool currently in use (T no.),
preselected tool (on milling machines) plus currently active motion
commands (e.g. G01, SPLINE, ...) or
tool radius compensation not active (e.g. G40).
The following values are displayed:
· "Path section" and "Stroke rate" are represented inverted if you
have programmed the automatic block division with "Path section
length" or "Number of path sections".
· The "delay time" can only be displayed if you have set "Punching
with delay time".
Zoom
act. val.
Increases the size of the actual-value display.
To Next Page
Loading...
Need help?
General
