Siemens SINUMERIK 840D

1
Introduction 03.04
1.2 Notes on handlin
g
1
Ó Siemens AG, 2004. All rights reserved
1-24 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
1.2 Notes on handling
Caution
The operator panel front/machine control panel may only be opened
by trained personnel for servicing purposes.
Danger
Never open the operator panel front/machine control panel unless the
power supply has been disconnected! Failure to comply could result in
fatal injury!
Warning
Electronic components inside the operator panel/machine control
panel might be destroyed by electrostatic discharge if they are
handled incorrectly.
Before operating any of the control elements on this operator panel
front:
Please first read the explanations supplied in this documentation!