Siemens SINUMERIK 840D

7
"Services" Operating Area 03.04
7.7 Start-u
p
functions
7
Ó Siemens AG, 2004. All rights reserved
7-398 SINUMERIK 840D/840Di/810D Operator's Guide HMI Advanced (BAD) – 03.04 Edition
Example:
Based on the original archive name MMCNCPLC, the new archive
name MMCNCPLC is suggested when you select PLC.
MMC data
selection
If you have selected the "MMC" area, you can select the data you
wish to archive by pressing softkey "MMC data selection". "MMC data
selection" stands for "HMI data selection".
The directory F:\USER is always backed up. Directories \ADD_ON
and \OEM can be saved additionally under "Additional products",
either completely ("Complete") or just the INI files ("Configuration").
The archiving operation commences when you select the target
device.
Archive data to:
RS-232
· The device connected to the RS-232 interface
PG
· Programming device/PC
Diskette...
· Floppy disk drive
Archives
· "Archives" directory on hard disk
NC card
· "Archives" directory on the NC card
· The softkey label changes to "Stop".
The series start-up archive is created.
Read start-
up archive
Toggle between functions "Create series start-up archive" and "Read
start-up archive".
Reading series start-up archive:
The read-in operation commences when you select the source device
connected to the RS-232 interface. The data can be read via:
RS-232
· A device connected to the RS-232 interface
PG
· A programming device
Diskette...
· The diskette drive
Archives
· The "Archives" directory on the hard disk
NC card
· The "Archives" directory on the NC card
· Select an archive file under softkeys "Diskette", "Archives"
and "NC card".
Start
· Start reading in the archive. The softkey label changes to "Stop".
Make start-
up archive
Switchover from "Read" to "Make".