Siemens SINUMERIK 840D - Page 502

A
Appendix 03.04
C References
A
Ó Siemens AG, 2004. All rights reserved
A-502 SINUMERIK 840D/840Di/810D Operator’s Guide HMI Advanced (BAD) – 03.04 Edition
/PJM2/
SIMODRIVE 611, MASTERDRIVES MC (03.04 Edition)
Planning Guide for Synchronous Servomotors
Content: General Part, 1FT5, 1FT6, 1FK6, 1FK7, 1FS6
Order No.: 6SN1197-0AC20-0BP0
/PJTM/
SIMODRIVE (05.03 Edition)
Planning Guide 1FW6 Integrated Torque Motors
Order No.: 6SN1197-0AD00-0BP1
/PJU/
SIMODRIVE 611 (02.03 Edition)
Planning Guide Inverters
Order No.: 6SN1197-0AA00-0BP6
/PKTM/
MASTERDRIVES (03.04 Edition)
Planning Guide 1FW3 Complete Torque Motors
Order No.: 6SN1197-0AC70-0BP0
/PMH/
SIMODRIVE Sensor (07.02 Edition)
Configuring/Installation Guide
Hollow-Shaft Measuring System SIMAG H
Order No.: 6SN1197-0AB30-0BP1
/PMH2/
SIMODRIVE Sensor (03.04 Edition)
Configuring/Installation Guide
Hollow-Shaft Measuring System SIMAG H2
Order No.: 6SN1197-0AB31-0BP1
/PMHS/
SIMODRIVE (12.00 Edition)
Installation Guide Measuring System for Main Spindle Drives
SIZAG2 Toothed-Wheel Encoder
Order No.: 6SN1197-0AB00-0YP3
/PMS/
SIMODRIVE (03.04 Edition)
Planning Guide
2SP1 ECO Motor Spindle for Main Spindle Drives
Order No.: 6SN1197-0AD04-0BP1
/PPH/
SIMODRIVE (12.01 Edition)
Planning Guide 1PH2, 1PH4, 1PH7 Motors
AC Induction Motors for Main Spindle Drives
Order No.: 6SN1197-0AC60-0BP0
/PPM/
SIMODRIVE (11.01 Edition)
Planning Guide
Hollow-Shaft Motors for 1PM4 and 1PM6 Main Spindle Drives
Order No.: 6SN1197-0AD03-0BP0