12/2008 3 Setting up functions
3.4 Fault services
© Siemens AG 2008 All Rights Reserved
ePS Network Services, Function Manual (FH) - Release 12/2008
3-145
Field Content Type
Start byte Start byte from which the data of the
data block will be loaded (inclusive)
DISPLAY
INPUT
(Digits from 0 to
99,999)
Number of bytes Number of bytes to be loaded, starting
from the start address.
DISPLAY
INPUT
(Digits from 0 to
999,999)
Description of functions "Trigger variable monitor(s)"
Using the "Trigger variable monitor(s)" action, the variables configured in the
selected variable monitors are read from the control and uploaded. In order to
execute variable monitors as an action in a control monitor, they must have been
configured beforehand. All configured variable monitors are offered for selection
here.
Fig. 3-44: Variable monitors – list view
Field Content Type
Trigger variable
monitor
At the trigger event, the variable monitor
acquires the variables that are configured
in the variable monitor.
In addition to a label indicating that they
have been selected, the background of
each variable monitor is highlighted in
yellow.
SELECTION
Labels show detailed information for each
variable monitor that is described in the
configuration of the variable monitors.
To Next Page
Loading...
