2 Maschine information 12/2008
2.2 Variable monitors - Measurements and measurement series
© Siemens AG 2008 All Rights Reserved
2-38 ePS Network Services, Function Manual (FH) - Release 12/2008
Function Description
Display in new diagram If the user clicks the "Display in new diagram"
button on the right-hand side next to the drop-
down list box, a new diagram of the same type will
be displayed below the diagram that is already
shown.
The regenerated diagram assumes all of the
display properties of the original diagram
(characteristic selected, markings, display,
selection and sequence of time series, etc.), with
the exception of its scale. In a new diagram, the
scale is always set to Auto/Auto.
Export diagram The data points represented in the diagram are
saved in a CSV file.
Changing the characteristic
Fig. 2-18: Drop-down list box for circularity test characteristics
The drop-down list box contains the list of characteristics for each test type. If the
user selects a characteristic, the diagram that has been displayed up to this point
will be replaced by the time series diagram for the characteristic selected.
"Actions" menu
Entries menu
Warm boot Regenerates the diagram.
All parameters A table containing the parameters for all of the
measurement series shown in the diagram is
displayed.
Fig. 2-19: Parameters for all measurement series
To Next Page
Loading...
