Mounting
7.3 Assembly and disassembly with different mounting systems
SIRIUS - SIRIUS 3RA load feeders
Manual, 09/2016, A5E03656507520A/RS-AB/003
99
⑤ Screw the main conductor terminals tight.
⑥ Snap the direct-on-line starter onto the busbar adapter.
⑦ Connect the connection cables to the applicable main conductor terminals.
⑧ Slide the positioning piece from below onto the busbar adapter until it engages at the bottom on the contactor.
Figure 7-41 Mounting on the busbar adapter (direct-on-line starter, screw-type connection system, size S0)
To Next Page
Loading...
Need help?
General