Qualification certificate
B
The qualification certificate is an enhancement of the PDM tool which enables printing of a
MAG 8000 status report using the MAG 8000 IrDA communication port and the MODBUS RTU
protocol.
Note
Scope
The MAG 8000 Qualification Certificate is a qualification report of device functionality and
NOT a tool for measurement accuracy verification like the MAG VERIFICATOR
(FDK-083F5060 or FDK-083F5061).
The MAG 8000 uses two main physical components for communication:
● The IrDA sensor on the MAG 8000
● An IrDA interface cable (with USB or RS 232 connector)
B.1 Commissioning
The qualification certificate is generated from PDM via the following steps:
1. Enabling insulation test
2. Uploading the device data to the PC
3. Generating the qualification certificate
Finally, the service technicians must evaluate the result.
SITRANS MAG 8000
Operating Instructions, 11/2018, A5E03071515-AE 129
To Next Page
Loading...
