5.1 General safety requirements
WARNING
The pertinent regulations must be observed for electrical installation.
● Never install the device with the mains voltage switched on!
● Danger of electric shock!
● The electrodes and magnetic current line may only be connected when the device is not
connected to the power supply.
● If the housing is under voltage (power supply), the cover may be unscrewed by qualified
personnel only.
WARNING
Mains supply from building installation Class II
A switch or circuit breaker (max. 15 A) must be installed in close proximity to the equipment
and within easy reach of the operator. It must be marked as the disconnecting device for the
equipment.
Connecting
5.1 General safety requirements
SITRANS MAG 8000
32 Operating Instructions, 11/2018, A5E03071515-AE
To Next Page
Loading...
