Battery backup input Male battery connector with black and red wires; black wire is ground. Male battery connector
has to be connected to female connector on backup battery
Functional ground Black wire with terminal must be connected to the device encapsulation with a screw
Cable installation
Choose the correct glands for the selected cable type, see Accessories (Page 157) for glands
selection. Ensure shield is mounted under cable clamps - do not make pig tails.
Note
Mains or line-powered PUR cable (no shield) has to be mounted under cable clamps. All cable
glands have to be sufficiently tightened to ensure IP-rating.
Connecting
5.3 Power supply
SITRANS MAG 8000
Operating Instructions, 11/2018, A5E03071515-AE 35
To Next Page
Loading...
