Fire Safety & Security Products
Building Technologies
1583_o_en_−−_6
116
08.2005
6.10 Serial port application BMS
Open interface to 3
rd
party systems
− building management system (BMS)
− driver module for mimic display panels for false floor etc. where element information
is required
Point-to-point connection
Monitored or non-monitored
Two way communication or restricted from FC330A to 3
rd
party systems only
Allows remote control of all important functions
User configuration and user texts are not transmitted
For protocol description consult local Alarmcom sales organization
Third party
system
RS232
or
Special TEST software
for remote control
SWE330A
Additional info
user text and standard text
for events also for event
memory and alarm counter
FC330A-> 3
rd
party system 3
rd
party system -> FC330A
detector zone ALARM with element address
remote ALARM
conTrol zone state ACTIVE / INACTIVE
general FAULT
mains FAULT
battery FAULT
detector zone FAULT with element address
remote FAULT
input 1−4 state ACTIVE as configured
−
−
−
−
−
−
−
−
−
detector zone DISABLED / ENABLED
conTrol zone DISABLED / ENABLED
set detector zone to DISABLED / ENABLED
set conTrol zone to DISABLED / ENABLED
detector zone TEST / CANCELLED (single)
detector zone TEST / CANCELLED (range)
detector zone TEST−ALARM with element address
set detector zone to TEST / CANCEL (single)
−
−
system ACK
system RESET
system on mode MANNED / UNMANNED
ACK system
RESET system
set system to MANNED / UNMANNED
OFFSET information request OFFSET information
request SATUS
For test purposes there is a software programm available that allows to operate the
FC330A remotely from a PC using the application BMS (on request available via hotline)
To Next Page
Loading...
