Fire Safety & Security Products
Building Technologies
1583_o_en_−−_6
115
08.2005
6.9 Serial port application VISU (Visualizer)
Application
− for remote indicating and operating via PC (available via hotline)
− only for demo and training sessions (non approved and non monitored communication)
− function ‘visualizer’ can be enabled or disabled via service menu (default = disabled)
− for the keyboard mapping consult the help menu in the visualizer
− the representation of the FC330A-LCD can be enlarged in the menu ‘Display’
Installation
The software ‘visualizer’ runs on WINDOWS 3.1 / 95 and has to be installed as follows:
− type ‘A:\setup’ on WINDOWS / execute and follow the instructions
COM1 (COM2)
Video beam
VGA
PC-Setup COM1:
− 9600 Baud
− 8 data bits
− NONE-Parity
− 1 stop bit
− xon/xoff protocol
or hardware
The function VISUALIZER can temporarily be
enabled via operating menu
S select option 2 to enable
S during operating via visualizer the key ’start/
stop’ on the panel is inactive
S the numeric keypad on the panel is accessible
after key ’start/stop’ has been activated via PC
CONFIGURATION: 1. user functions
(4.4) 2. user text
3. service functions
4. erase functions
SERVICE 1. addr. line −> CONNECT
level : 2. addr. line −> DISCON.
4. reconfigure addr. lines
5. horn/ctrl/RT −> OFF
6. TEST−alarm −> HORN
7. Visualizer ON/OFF
VISUALIZER active on port: ###### 1.no
> selected #, change? 2.yes
RS232 K11 (K12)
Cable D-Sub 9 conductors
(1:1) male/female
To Next Page
Loading...
