Siemens Synova FC330A - Overview Operating Menu

Fire Safety & Security Products
Building Technologies
1583_o_en_−−_4
62
08.2005
4.5 Overview operating menu
Call up the operating menu:
 Press «start/stop» key and enter the password (0055 ok), or turn key
Enable zones 1...256 
Access level
0055
Enable ELEMENTS within zone 
Enable conTrol zone 
Enable control lines 1...4 for alarm horns 
Enable alarm contacts 1...4 
Enable remote transmission ALARM 
Enable only event logging or all messages 
Enable remote transmission FAULT 
Disable detector zones 1...256 
disabling permanent or for a set time 1...98h
Disable control line 1..4 for alarm horns 
Disable alarm contacts 1...4 
Disable remote transmission ALARM 
Disable only event logging or all messages 
Disable remote transmission FAULT 
Disable detector ELEMENTS within zone 
disabling permanent or for a set time 1...98h
Disable conTrol zones 1....64 
View fault messages 
View turned off system components 
View pre-alarm messages 
View ELEMENT states 
View reviewing event list 
View number of alarms and remote alarms 
View general parameter settings 
View parameter settings coll. lines 
View user texts detector zones/elements 
View user texts control zones 
View parameter settings detector zones 
View parameter settings addr. lines 
View parameter settings LON-bus 
Enable all fire conTrol zones 
Disable all fire conTrol zones 
SELECT: 1. ENabling
(main menu) 2. DISabling
3. INFO polling
4. other functions
ENABLE: 1. Detector/ConTrol ZONES
(1) 2. horn/RT/alarm contacts
3. printer
ENabling: 1. detector ’zone’
(1.1) 2. detector ’element’
3. ConTrol ’zone’
4. All Fire Ctrl ’zones’
ENabling: 1. horn
(1.2) 2. alarm contacts
3. RT−alarm
4. RT−fault
ENable printout messages: 1. log ALL
(old: #) 2. only ALARMS 3. log NONE
Enable only alarms or none 
SELECT: 1. ENabling
(main menu) 2. DISabling
3. INFO polling
4. other functions
DISabling: 1. detector/ConTrol ZONES
(2) 2. horn/RT/alarm contacts
3. printer
DISabling: 1. detector ’zone’
(2.1) 2. detector ’element’
3. ConTrol ’zone’
4. All Fire Ctrl ’zones’
DISabling: 1. horn
(2.2) 2. alarm contacts
3. RT−alarm
4. RT−fault
ENable printout messages: 1. log ALL
(old: #) 2. only ALARMS 3. log NONE
Disable only alarms or none 
SELECT: 1. ENabling
(main menu) 2. DISabling
3. INFO polling
4. other functions
INFO: 1. system status
(3) 2. event memory/alarm counter
3. configuration/user text
4. configuration zone/line/LON
STATUS: 1. fault
(3.1) 2. isolation
3. pre−alarm
4. techn.alarm /element status
MEMORY: 1. event memory
(3.2) 2. alarm counter
INFO: 1. configuration system
(3.3) 2. configuration coll line
3. user text detector zn/elem
4. user text ConTrol zone
INFO: 1. configuration det. zones
(3.4) 2. configuration addr. lines
3. configuration LON devices