Fire Safety & Security Products
Building Technologies
1583_o_en_−−_2
20
08.2005
2.3 Panel preparation FC330A-ECO... (1 loop)
Pull out with screwdriver in
order to detach the relay
module from the profile rail
Place batteries and inserted jumper ”ST8/9 or ST10”
according to the battery make used
ST8 Yuasa
ST9 ALARMCOM (default) / Power sonic
ST10 Sonnenschein (more info see page 106)
Insert EPROMs
Insert inscription stripes
Snap the Z3B171 relay on
to the profile rail
If mains voltage 230/115VAC is applied for
controls, fasten cables with cable tie and
stick warning label close to the relay units
4
1
2
EP2
EP1
External voltage
side (contacts)
Control unit voltage side (coil)
max. 4 relays possible
ST8
ST9
ST10
3
Master board
(K3X030)
Danger external voltage
AX1212
AX1212
To Next Page
Loading...
