Fire Safety & Security Products
Building Technologies
1583_o_en_−−_5
93
08.2005
Define parameters on (c.9) 2. ConTrol ELEMENTS
(continuation)
Submenu 4. addressable line
to define line type, number of devices, link devices
to define device parameters
to define zone parameters
to define element parameters
to link conventional lines to zone (if available)
to check configuration before exit the programming mode
to delete all user data
to read actual line configuration as installed
to define control outputs
CONFIGURATION 1. line
(c) 2. device
3. zone
4. element
5. line ’collective’
6. CHECK configuration
7. CLEAR configuration
8. AUTOM. configuration
9. CONFIG ConTrol−ZONES
ConTrol zn ### ConTrol elem ##: selected conTrol zone and conTrol element
(ConTrol zone trig type: ######) information selected TRIGGER category
1. name ######
2. trouble ###### 3. signal ######
CONFIGURE: 1. ConTrol ZONES
(c.9) 2. ConTrol ELEMENTS
3. link DRIVER OUT’s
4. link RELAY OUT’s
5. link LON OUT’s
1. to select device type of addressable output devices
either AB or ABI_out (AB322A channel ‘output’) or DC92out (DC1192 as ’output’)
no access to this option if element is linked to ’driver output’ or ’relay output’
2. to define function of state ‘device fault’ either FAULT or INFO
3. to define whether signal is (PULSE) ON (steady)
this option is not available if element is linked to an ’addressable output device’
To Next Page
Loading...
