AT Command Set
TC3X_ATC_01_V04.00 Page 112 of 204 29.05.2002
4.40 AT+CSCS Set TE character set
Test command
AT+CSCS=?
Response
+CSCS: (list of supported <chset>s)
OK
Read command
AT+CSCS?
Response
+CSCS: <chset>
OK
Write command
AT+CSCS=[<chset>]
Response
Write command informs TA which character set <chset> is used by the TE.
TA is then able to convert character strings correctly between TE and ME
character sets.
OK
Parameters
<chset>:
"GSM" GSM default alphabet (GSM 03.38 subclause 6.2.1);
Note: This setting may cause software flow control problems since
the codes used to stop and resume data flow (XOFF = decimal 19,
(XON = decimal 17) are interpreted as normal characters.
"UCS2" 16-bit universal multiple-octet coded character set (ISO/IEC10646
[32]); UCS2 character strings are converted to hexadecimal
numbers from 0000 to FFFF; e.g. "004100620063" equals three
16-bit characters with decimal values 65, 98 and 99, $(AT R97)$
Reference
GSM 07.07
Note
· Also see chapter 1.5 (“Supported character sets”).
· When TA-TE interface is set to 8-bit operation and used TE alphabet is
7-bit, the highest bit will be set to zero.
To Next Page
Loading...