Siemens TC37 Module - AT^SLCK Facility Lock

AT Command Set
TC3X_ATC_01_V04.00 Page 157 of 204 29.05.2002
6.13 AT^SLCK Facility lock
Test command
AT^SLCK=?
Response
^SLCK: (list of supported <fac>s) OK
Parameter
See write command
Write command
AT^SLCK=
<fac>,<mode>
[,<passwd>
[,<class>]]
Response
This command is used to lock, unlock or interrogate a ME or a network facility
<fac>.
The command can be aborted while network facilities are being set or
interrogated.
If <mode><>2 and command is successful
OK
If <mode>=2 and command successful
^SLCK: <status>[,<class1>[<CR><LF>
^SLCK: <status>, class2....]] OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
<fac> Phone security locks set by user / provider
“PS” Phone locked to SIM card (phone code). ME requests password
when other than current SIM card inserted; ME may remember
certain number of previously used cards thus not requiring
password when they are inserted.
“SC” SIM (lock SIM cards). SIM requests password upon ME power-up
and when this lock command issued.
“FD” SIM fixed dialling memory: If the mobile is locked to FD, only the
numbers stored to the FD memory can be dialled (up to 7
numbers). If PIN2 authentication has not been performed during the
current session, PIN2 is required as <passwd>.
"CS" Keypad lock (not supported since keypad cannot be connected)
Supplementary Service: Call barring
“AO” BAOC (Bar All Outgoing Calls)
“OI” BOIC (Bar Outgoing International Calls)
“OX” BOIC-exHC (Bar Outgoing International Calls except to Home
Country)
“AI” BAIC (Bar All Incoming Calls)
“IR” BIC-Roam (Bar Incoming Calls when Roaming outside the home
country)
“AB” All Barring services (applicable only for <mode>=0)
“AG” All outGoing barring services (applicable only for <mode>=0)
“AC” All inComing barring services (applicable only for <mode>=0)
Factory set facility locks:
“PF” lock Phone to the very First SIM card
“PN” Network Personalisation
“PU” Network subset Personalisation
“PP” Service Provider Personalisation
“PC” Corporate Personalisation