Siemens TC37 Module - AT^SMSO Switch off Mobile Station; AT^SM20 Set M20 Compatibility

AT Command Set
TC3X_ATC_01_V04.00 Page 162 of 204 29.05.2002
6.18 AT^SMSO Switch off mobile station
Test command
AT^SMSO=?
Response
OK
Execute command
AT^SMSO
Response
^SMSO: MS OFF OK
Device will be switched off (power down mode)
Reference
Siemens
Note
Do not send any command after this command
6.19 AT^SM20 Set M20 Compatibility
Test command
AT^SM20=?
Response
OK
Read command
AT^SM20?
Response
^SM20: <n>
OK
Parameters
See write command
Write command
AT^SM20=<n>
Response
Response
M20 is an earlier, widely used SIEMENS GSM engine. The AT^M20 command
simply controls the behaviour of the ATD command during voice calls. Please
note that this command has no effect on any other differences between M20
and products based on x35/37 firmware.
OK
Parameters
<n> 0 Compatible to x35/37mobiles.
If this mode is active, TA returns OK right after attempting a
call.
1 Compatible to M20.
If the M20 mode is active, TA returns OK once the call is
successfully set up. Issuing any command before TA returns
OK will cancel the call setup.
Reference
Siemens
Note