Siemens TC37 Module - AT+FCQ Copy Quality Checking; AT+FCR Capability to Receive

AT Command Set
TC3X_ATC_01_V04.00 Page 46 of 204 29.05.2002
3.6 AT+FCQ Copy Quality Checking
Test command
AT+FCQ =?
This command controls Copy Quality checking when receiving a fax.
Response
(list of supported copy quality checking <cq>s)
OK
Parameter
See write command
Read command
AT+FCQ?
Response
<cq> OK
Parameter
See write command
Write command
AT+FCQ =<cq>
Response
OK
Parameter
<cq> 0 No copy quality checking. The ME will generate Copy
Quality OK (MCF) responses to complete pages.
1 ME can check 1-D phase data. The connected application
must check copy quality for 2-D phase C data
Reference
EIA PN-2388
Note
Used for for Faxclass 2 only.
3.7 AT+FCR Capability to receive
Write command
AT+FCR=<cr>
Response
OK
Parameter
<cr> 0 ME will not receive message data. This can be used when
the application has insufficient storage. The ME can send
and can be polled for a file.
1 ME can receive message data.
Reference
EIA PN-2388
Note
Used for Faxclass 2 only