Siemens TC37 Module - AT+CPBS Select Phonebook Memory Storage

AT Command Set
TC3X_ATC_01_V04.00 Page 94 of 204 29.05.2002
4.29 AT+CPBS Select phonebook memory storage
Test command
AT+CPBS=?
Response
+CPBS: (list of supported <storage>s) OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
See write command
Read command
AT+CPBS?
Response
TA returns currently selected memory:
+CPBS: <storage>,<used>,<total> OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
See write command
Write command
AT+CPBS=
<storage>
Response
TA selects current phonebook memory storage, which is used by other
phonebook commands.
OK
If error is related to ME functionality:
+CME ERROR: <err>
Parameter
<storage> “SM” SIM phonebook (storage depends on SIM Card)
“FD” SIM fixdialling phonebook (FD Phonebook storage pos.1-7).
If the mobile is locked to FD, only the numbers stored to the
FD memory can be dialled. To edit the FD phonebook PIN 2
is required. See AT+CLCK Facility lock and AT^SLCK
Facility lock.
“LD” SIM last-dialling-phonebook (LD Phonebook storage pos.1-
10) (+CPBW not be applicable to this storage)
“MC” ME missed (unanswered received) calls) (MC Phonebook
storage pos.1-10) list (+CPBW not applicable to this storage
“RC” ME received calls list (+CPBW not applicable for this
storage) (RC Phonebook storage pos.1-10)
“ON” SIM (or ME) own numbers (MSISDNs) list
“ME” ME Phonebook (storage pos.1-50)
<used> Integer type value indicating the number of used locations in
selected memory
<total> Integer type value indicating the maximum number of locations
allowed in the selected memory
Reference
GSM 07.07
Note
This command can be used right after power-on to get selected <storage>.
Since data need to be loaded from the SIM, values of <used> and <total> might
not be available for the first 20 seconds.