Siemens TC37 Module - AT+FTM Transmit Data; AT+FTS Stop Transmission and Wait

AT Command Set
TC3X_ATC_01_V04.00 Page 55 of 204 29.05.2002
3.25 AT+FTM Transmit Data
Test command
AT+FTM=?
Response
(List of supported modulation modes) OK
Parameter
See write command
Write command
AT+FTM=<mod>
This command causes the TA to transmit data using the modulation mode
defined below. An ERROR response code results if this command is issued while
the modem is on-hook.
Response
CONNECT
If error is related to ME functionality:
ERROR
Parameter
<mod> modulation mode
96 V.29 9600 bps
72 V.29 7200 bps
48 V.27ter 4800 bps
24 V.27ter 2400 bps
Reference
TIA/EIA-578
Note
Used for Fax class 1 only
3.26 AT+FTS Stop Transmission and Wait
Write command
AT+FTS=<time>
This command causes the TA to terminate a transmission and wait for <time> 10
millisecond intervals before responding with the OK result code to the DTE.
Response
An ERROR response code results if this command is issued while the modem is
on-hook.
Parameter
<time> 0 – 85 no. of 10 millisecond intervals
Reference
TIA/EIA-578
Note
Used for Fax class 1 only