Siemens TC37 Module - ATS5 Write Command Line Editing Character; ATS6 Set Pause before Blind Dialling

AT Command Set
TC3X_ATC_01_V04.00 Page 29 of 204 29.05.2002
2.24 ATS5 Write command line editing character
Read command
ATS5?
Response
<n> OK
Write command
ATS5=<n>
This parameter setting determines the character recognized by TA as a request
to delete the immediately preceding character from the command line.
Response
OK
Parameter
<n> 000-008-127 command line editing character
Reference
V.25ter
Note
2.25 ATS6 Set pause before blind dialling
Read command
ATS6?
Response
<n> OK
Write command
ATS6=<n>
No effect for GSM
Response
OK
Parameter
<n> 000-255 number of seconds to wait before blind dialling.
Reference
V.25ter
Note