Siemens TC37 Module - Atd><Str> Originate Call to Phone Number in Memory with Corresponding Field

AT Command Set
TC3X_ATC_01_V04.00 Page 21 of 204 29.05.2002
2.8 ATD><str> Originate call to phone number in memory with
corresponding field
This command searches the active phonebook for a given string <str> and dials the assigned phone
number. The active phonebook is the one set with AT+CPBS.
Execute command
ATD><str>[mgsm][;]
TA attempts to set up an outgoing call to stored number
Note: This command may be aborted generally by receiving a character
during execution. It can´t be aborted in some connection setup states,
such as handshaking.
Response
If error is related to ME functionality:
+CME ERROR: <err>
If no dialtone (parameter setting ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If a connection cannot be set up:
NO CARRIER
If successfully connected and non-voice call:
CONNECT<text> TA switches to data state.
Note: <text> output only if +ATX parameter setting with value > 0.
When TA returns to command mode after call release:
OK
If successfully connected and voice call:
OK
Parameter
<str> string type value (“x”), which should equal an alphanumeric field in
at least one phonebook entry in the searched memories; used
character set should be the one selected with Select TE Character
Set +CSCS. <str> can contain escape sequences as described in
chapter „“, pg. 11.
<str> must be wrapped in quotation marks (""), if escape sequences
or parameter <mgsm> are used or if the alphanumeric strings
contains a blank. If not, quotation marks are optional.
<mgsm> I Activates CLIR (disables presentation of own phone number to
called party)
i Deactivates CLIR (enables presentation of own phone number to
called party)
<;> Only required to set up voice calls. TA remains in command mode.
Reference
V.25ter/GSM 07.07
Note
Command is not supported for data calls! See also ATX and Chapter 7.1.4 for
<text>