Parameterizing Steps 05.2006
6SE7087-2JD60 Siemens AG
9-4 Operating Instructions SIMOVERT MASTERDRIVES
Parameter number Parameter name
P053 Parameterization enable
P696 SCB protocol
P700 SST bus address
P701 SST baud rate
P702 SST PKW number
P703 SST PZD number
P704 SST frame failure
Table 9-3 The factory setting is made via interface SCB2: Parameters that are not
changed by the factory setting either. None of the indices of the
parameters is changed.
Parameter number Parameter name
P053 Parameterization enable
P711 to P721 CB parameters 1 to 11
P722 CB/TB frame failure
P918 CB bus address
Table 9-4 The factory setting is made either via interface 1.CB/TB or 2.CB/TB:
Parameters that are not changed by the factory setting either. None of
the indices of the parameters is changed.
Parameter factory settings which are dependent on converter or motor
parameters are marked with '(~)' in the block diagrams.
NOTE
To Next Page
Loading...
