EasyManua.ls Logo

Silhouette CURIO 2

Silhouette CURIO 2
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
Before using this machine, please read this manual
Before using this machine, please read this manual
Precautions for Silhouette CURIO2 Handling
In order to use the Silhouette CURIO2 safely and correctly, as well as to establish an excellent cut, be sure to read
the following describes important points thoroughly prior to use.
CAUTION
●Toavoidbodilyinjury,handlecutterbladeswithcare.
●Physicaldamagetothenewmachinecausedbycustomerswillnotbecoveredbythewarranty,
unfortunatelywecannotofferyouanexchangethemachineorcutterblade.
Always make a test cut before cutting
If cutting conditions such as Blade Depth, Force and Speed are not appropriate, the blade tip may break or the
Electrostatic Bed may be damaged. Also, the expected cutting results may not be obtained and the media may be
wasted.
Optimal cutting conditions vary depending on the thickness and quality of the media used and the degree of wear
of the cutter. Make a test cut every time you change the media.
Blade Depth as a guideline
ThemostimportantsettingincuttingistoadjusttheBladeDepth.Adjustso
thatthebladeprotrudesslightlymorethanthethicknessofthemediatobe
cut.
Whencuttingthecuttinglm,extendthecutterblademorethanthelmbut
notthroughthereleasepaper.
Thickness of film
Thickness of release paper
Appropriate Blade Depth
= Thickness of film + α
Completely cutting out
to the release paper
Film not clipped.
Be sure to use the Electrostatic Bed Protection Sheet
The Silhouette CURIO2 uses an electrostatic writing panel to x the media.
If the surface of the electrostatic bed is damaged, the high voltage part will be exposed, which is very dangerous.
In addition, it may cause a decrease in adsorption force.
Be sure to use the Electrostatic Bed Protection Sheet.
Precautions after powering on the Silhouette CURIO2
When the power is turned on, the Y bar moves toward you. Do not let your hands, hair, or clothing get too close to
the moving parts or do not place any foreign objects in or near these areas either.
If your hands, hair, clothing, or the like get caught in, or wrapped around moving parts, you may be injured and the
machine may be damaged.

Related product manuals