SimpliVity OmniCube CN-2000 - Verifying Esxi Shell and SSH Are Enabled; Configuring the Management Network Adapters

CN-Series Hardware Installation and Maintenance Guide Verifying ESXi Shell and SSH are Enabled
Verifying ESXi Shell and SSH are Enabled
ESXi Shell and SSH are enabled by default.
Before You Begin
• You have configured IPMI and launched the Virtual Console.
• You have logged in to VMware ESXi.
To verify that ESXi Shell and SSH are enabled:
1. Select Troubleshooting Options in the ESXi System Customization screen.
2. Verify that both ESXi Shell and SSH are enabled.
Related Topics
Task 5—Configuring IPMI for Remote Management on page 27
Connecting to IPMI and Launching the Virtual Console on page 30
Accessing VMware ESXi Through the IPMI Virtual Console on page 33
Configuring the Management Network Adapters
You select the 1 GbE network adapters to use for the Management network. This procedure is specific ESXi
5.1. The assigned device names, for example, might be different for ESXi 5.5.
Before You Begin
• You have configured IPMI and launched the Virtual Console.
• You have logged in to VMware ESXi.
To configure the management network adapters:
1. Select Configure Management Network in the System Customization screen.
2. Select Network Adapters to display the Network Adapters configuration screen.
34