Safety 2
man-CH-PVF-C-V17-2 Minilab 7
ELECTRICAL POWER
(STC #596-296-020)
This label is located inside the panel enclosure on the right side,
above the manometer.
With the panel enclosure door open, the electrical power supply and
electrical terminals are exposed. A hazardous voltage is present, can
cause electric shock or burn and will result in serious injury. Follow
Lockout and Tagout procedures before servicing.
READ AND UNDERSTAND ALL SERVICE MANUAL
INSTRUCTIONS
(STC #998-4731)
This label is located on the left side of the panel enclosure above the
main switch.
Before operating and/or performing any maintenance or repair on
Simpson Technologies designed and/or manufactured equipment, it is
required that all personnel read and understand the entire Operating
Instructions manual. All protective guards and covers shall be installed
and all doors closed before operating the equipment. If any questions
remain unanswered, you must contact your supervisor or Simpson
Technologies before taking further action. Follow Lockout and
Tagout procedures before servicing.
To Next Page
Loading...
