Initial Configuration
25
Press the ◄ key, the display will change to the “Vessel Configuration
Information” window (Section 4.3.2), to enter the remaining ships
configuration information.
If the two entered MMSI numbers do not match, a message indicating this
will be shown Fig 4.8.
Press the ◄ key, the display will revert back to the Configuration Request
window Fig. 4.3.
If you need to cancel the input mode, highlight the CANCEL button and
press MENU. A warning will be shown in the display Fig. 4.9.
Press the ◄ key, and the display will revert back to the Configuration
Request window Fig. 4.3.
Once the MMSI number has been entered and confirmed, the next stage
of the configuration is highlighted. The MMSI number is now shown as
greyed-out and locked into the system memory; no further changes can be
made to it except by an authorised agent. Fig. 4.10.
4.3.2 Vessel Type Entry
Press MENU or ► to select “ Vessel type”, “Not Set” will be
highlighted. Fig. 4.11.
Fig. 4.8 - MMSI mismatch warning
Fig. 4.9 - MMSI cancelled warning
Fig. 4.10 – Vessel confi guration list
To Next Page
Loading...
Need help?
General
