Installation
20222410 / B 27
Installation setting summary:
S1 to S4: External/Internal ref. voltage and
voltage/current control (ref. Figure 2-17 to
Figure 2-19).
S5: For open/closed or always closed analog
signal line(s), ref. page 28.
Always closed
Open /closed depending on
system status
CPU RUNNING: Alternating green when JD53 is operative
(ref. setting of DIP switch SW1).
ON: Green when Autopilot ON relay is activated
(ref. page 24).
MODE: Green when MODE relay is activated (ref.
page 24).
CONTROL Green when control signal lines are closed
(ref. page 22).
DIP SWITCH
setting
Settings for analog steering
(CPU running alternates at 1 Hz)
Settings for alarm interface
(CPU running alternates at 2 Hz)
For future use
(CPU running alternates at 0.5 Hz)
Other settings (illegal)
(CPU running alternates at 4 Hz)
To Next Page
Loading...
