Installation
20222410 / B 37
• Change in the Installation Interface menu: Select FLUX =
ROBNET.
• Select FLUX as compass in the User Set-up Menu to activate
the RC25 as the steering compass.
• Perform the compass calibration as described on page 67.
Note ! After turning on, the compass will stabilize in less than 30
seconds, but it will need another 10 minutes to fully utilize
information from the rate sensor.
Refer to Compass Offset on page 68 to compensate for any
permanent offset after the calibration is completed.
Calibration data is stored in the compass and will not be deleted
by a Master Reset in the autopilot. However, offset
compensation must be reset.
2.11 FU50 Steering Lever
For connection of the FU50 Steering Lever, see the FU50
manual.
2.12 TI51 Thruster Interface
The TI51 Thruster Interface is designed to provide control signal
for operating one thruster in an AP50 system by either on/off
solenoid, continuous control, or Sauer Danfoss PVEM valve.
Refer to separate manual for the TI51 Thruster Interface.
To Next Page
Loading...
