Simrad GC80/GC85 Expanded Gyro Compass
24 20221529 / C
4 Remove the four screws securing the Sensitive element.
Tilt the Horizontal ring to the side where the plug is
located, and carefully remove the element from the
compass.
5 Place the defective Sensitive element in its original
package, and put the rubber tube on top of the element.
6 Re-install the plug-holder on the defective Sensitive
element.
7 Lift the new element carefully from its package, and
remove the rubber tube on top of the element.
Note! The package and the rubber tube should be kept for re-use if the
Sensitive element has to be sent to factory for service!
To Next Page
Loading...
