INSTALLATION
20221529 / C 51
Setting the Latitude input system
The latitude input system may be changed during the settling
process of the start-up procedure from item 7 onwards.
1 Press the DISP button until the display shows latitude
value.
2 Press SET button once, and the upper line in the display
starts flashing.
3 Use the arrow buttons for selecting Gyro or GPS as the
latitude input system, and confirm the entry with the
ACK/ENT button.
4 The display will change to flashing number.
5 Press the arrow buttons for increasing/decreasing the
latitude value, and confirm the entry with the ACK/ENT
button.
- This entered latitude value will now be used, together
with speed and bearing information, for calculating the
vessel’s current latitude.
6 The display will return to show latitude value without
flashing.
To Next Page
Loading...
Need help?
General
