the temperature reading may be inaccurate or not available at all if
the wrong transducer is selected. Transducer temperature sensors
are one of two impedances - 5k or 10k. Where both options are
given for the same model transducer, refer to paperwork supplied
with transducer to determine impedance.
Restore echosounder defaults
Restore echosounder settings to the factory supplied defaults.
ForwardScan installation
Available when a ForwardScan transducer is connected.
For setup information, refer to the Operator Manual.
Settings for the 12" units
The 12" GO units can share echosounder data over the Ethernet
network with other 12" GO units, other capable sonar modules and
display units.
Ú
Note: The 12" units cannot share StructureScan 3D data over
the Ethernet network.
The following echosounder settings are available for setting up the
sharing of the data.
Internal Echosounder
When selected, the internal echosounder is available for selection in
the echosounder panel menu.
When unselected, this option disables the internal echosounder in
the unit. It will not be listed as an echosounder source for any unit
on the network. Unselect this option on units which do not have a
transducer connected.
Network Echosounder
Select to share transducers from this unit with other units
connected on the Ethernet network. In addition, the setting must
be selected in order to see other enabled sonar devices on the
network.
When unselected, transducers connected to this unit cannot be
shared with other units connected on the network, nor can it see
other sources on the network that have this feature enabled.
44
System setup | GO XSE/XSR Installation Manual
To Next Page
Loading...
Need help?
General
