System setup
Turning the system on and off
The system is turned on by pressing the Power key.
Press and hold the Power key to turn the unit off.
If the key is released before the shut-down is completed, the power
off process is cancelled.
You can also turn the unit off from the System Controls dialog.
First time startup
When the unit is started for the first time, or after a reset, the unit
displays a series of dialogs. Respond to the dialog prompts to make
fundamental settings.
You can perform further setup and later change settings using the
system settings dialogs.
System setup sequence
1 General settings - refer to "System settings" on page 33.
• Make general settings as desired.
2 Advanced settings - refer to "Advanced" on page 34.
• Enable or disable features.
• Review the advanced setting options and make changes
as desired.
3 Source selection - refer to "Network settings" on page 51.
• Make sure that the proper external data sources have
been selected.
4 Feature setup
• Configure specific features as described later in this
chapter.
The settings dialog
The system setup is done from the settings dialog.
4
32
System setup | GO XSE/XSR Installation Manual
To Next Page
Loading...
Need help?
General
