Connect to a wireless hotspot
Displays the Wireless device dialog that you can use to connect the wireless functionality to a
wireless hotspot.
Remote controllers
When a wireless device (smart phone or tablet) is connected, it should appear in the Remote
controllers list. Selecting Always allow means the device can automatically connect without
needing a password each time. This menu also allows you to disconnect devices that no
longer require access.
Wireless devices
This dialog shows the internal wireless and any connected WIFI-1 devices, as well as their IP
and channel number. Selecting the internal wireless or a WIFI-1 device provides additional
detail.
To view and change internal wireless detail values (Network Name (SSID), Network Key, or
Channel) the internal wireless must be in Access Point (Internal Wifi) mode. To select a
network (hotspot) to connect to, the internal wireless must be in Client Mode. Use the
Mode option to change modes.
Client settings
Displays information about the wireless hotspot your unit is connected to or the last one
your unit was connected to. You can select the hotspot in the dialog to set it as a hotspot
you want to always connect to when in range or you can select to delete it.
Advanced
Initiates the Iperf and DHCP Probe tools that help in fault-finding and setting up the wireless
network.
Ú
Note: Iperf and DHCP Probe are tools provided for diagnostic purposes by users familiar
with network terminology and configuration. Navico is not the original developer of
these tools, and does not provide support related to their use.
Internal Wireless
Select this option to enable or disable the internal wireless module.
Disabling wireless when not in use reduces the unit’s power consumption.
104
Wireless connection | NSO evo3 Operator Manual
To Next Page
Loading...
Need help?
General
